Masonry mortar

Masonry mortars are stiff to plastic in consistency and are used when laying clinker bricks in sewers and shafts. Berms can be installed using bricklaying mortar. The grain-size is < 4mm. The job of masonry mortar is to join blocks and stone firmly and permanently. Essentially, it transfers stresses and evens out any unevenness between two elements in the construction. The brickwork must be carefully pointed throughout. Where a higher level of corrosion protection is required, the grouting must be raked out to a depth of about 2cm and then regrouted with a more resistant pointing mortar.

 

ERGELIT-KS1

Overview

All-in-one mortar with organic and inorganic additives, which hardens in a few seconds even under water.

 

 

Technical info

  • Granular powder
  • Particle size ˂ 1mm
  • Consistency: stiff
  • Rapid hardening
  • Does not shrink in wet conditions
  • Resistant to acid and alkalis
  • Excellent adhesive characteristics
  • Waterproof
  • Oil resistant

Areas of Application

  • For coating leaking pipes
  • For repairing concrete and for sealing pipes against water ingress.
  • For coating floors
  • walls or roofs against water penetration

ERGELIT SBM

Overview

All-in-one cement based mortar, with organic and inorganic additives and high early strength.

  • granular powder
  • size of particles < 3,5 mm
  • consistency: can be worked as a stiff mix by hand

Technical info

  • fast drying
  • high stability
  • no shrinking in wet conditions
  • expanding > 0.1 vol %
  • high resistance to dynamic forces
  • good adhesive properties
  • waterproof
  • can be applied in thick layers

Areas of Application

  • sandwich construction and repair of concrete parts;
  • construction mortar for manholes, conduits, sewers and reservoirs; fixing of manhole covers and paving stones